4. Press and hold the "LOCK" button to test the
"Panic" function. The alarm should blow the
horn in short continuous blasts and the parking
lights and dome lights should be flashing. Press
and release the “LOCK” button to stop “PANIC”.
D. SHOCK SENSOR:
1. Press and release the "LOCK" button to arm the
system. Wait 10 seconds, then with the open
palm lightly slap the "A" pillar by the driver's
windshield. You should hear short chirps from
the vehicle horn. This is a check of the shock
sensor "WARN-AWAY" function. Allow a few
seconds for the shock to settle, then conduct
the same check at various points around the
vehicle. Sensitivity can be adjusted at the shock
sensor for best response.
2. Slap the vehicle at the "A" pillar with slightly more
force. The vehicle should go into full alarm.
Press and release the "UNLOCK" button to
disarm the system. Rearm the vehicle and
conduct the same check at various points
around the vehicle. Adjust sensitivity at the
shock sensor for the best response.
TESTING THE ALARM SYSTEM:
A. Test BOTH remote transmitters, one at a time. Press and release the "LOCK" button. If the LED light on
the transmitters fails to glow, you need to check the transmitter battery. (Refer to the section on battery
replacement in the Owner's Manual.)
SHOCK SENSOR
sensitivity adjustment
LED Light
Green Button
Lock Button
B. VALET CONTROL SWITCH:
1. Sit in the driver's seat, insert the ignition key and
turn to the ON position.
2. Press the valet control switch and verify that the
LED light responds. Light should go ON and
OFF with actuation of the valet control switch.
3. With the LED indicator light ON, ignition OFF and
key removed, the security system is in the valet
mode and the alarm should not arm. Press and
release the "LOCK" button; all doors will lock
but the LED will not flash. Press and release
the "UNLOCK" button; the driver's door will
unlock.
4. Switch the ignition key ON, and turn the LED
light OFF. Remove the key.
C. ARMING / DISARMING & PANIC:
1. Put the driver’s window down and close the trunk,
hood and all doors.
2. Press and release the "LOCK" transmitter button.
All doors lock, parking lights flash once, horn
chirps once, headlights come on for 20 seconds
and the LED should flash slowly. (If the parking
lights flash three times and the horn chirps three
times, check for an open trunk, hood or door.)
3. Press and release the "UNLOCK" transmitter
button. Driver's door unlocks, parking lights flash
(2) times, the horn chirps (2) times, headlights
and dome light come on for 20 seconds.
Page 4
Unlock Button
