-7-
ELIMINATING THE NORMAL ARM/DISARM BEEPS OR CHIRPS:
You can selectively eliminate the normal arm and disarm beeps or chirps by holding
the lock or unlock button slightly longer when arming and disarming. This will
prevent the Horn or Siren beeps or chirps for one arm or disarm cycle. If you wish
to disable these beeps or chirps all the time:
Start with the valet/override switch in the off position. Turn the ignition switch on,
then off. Within 10 seconds of turning off the ignition, flip the valet switch on, off,
on, off, on, then off. If the beeps or chirps were enabled before you started, the
Horn or Siren will emit two short beeps or chirps indicating that the beeps or chirps
are now disabled. If the beeps or chirps were disabled before you started, the
Horn or Siren will emit one short beep or chirp indicating that the beeps or chirps
are now enabled.
NOTE:
If the beeps or chirps have been disabled, this effects only the normal one
beep or chirp (arm/lock) and the two beep or chirp (disarm/unlock) beeps or chirps.
The three beep or chirp defective zone and the four beep or chirp tamper indication
remain operational. These beeps or chirps are for safety and will not be disabled.
If the vehicle battery is disconnected for servicing, when power is restored, the
arm/disarm beeps or chirps will revert to normal operation.
REMOTE PANIC OPERATION:
The panic feature can be operated from the maximum operating range of your
keychain transmitter. Access to the panic feature can be programmed to operate
from the transmitter button with the red lock symbol on it or can be operated from
a dedicated panic button as shown on page one of this manual. In either case,
dedicated panic button or operation from the lock button, press and hold this
button for 3 seconds to activate the panic feature. Once activated, the Horn or
Siren will sound and the parking lights will flash for a period of 30 seconds. If you
wish to cancel the panic mode anytime during the 30 second cycle, press and
release the button used to activate the feature.
REMOTE SHOCK SENSOR CONTROL:
The shock sensor feature of your security system is intended to detect strong
vibrations or impact to the vehicle when attempted break-ins are made to the
vehicle's glass. The shock sensor is operational every time you lock/arm
your security system. It may be necessary at times to disable the
pre-detect stage of the optional Dual Stage Shock Sensor for one
arming cycle because of harsh thunder storms or when parking along routes of
heavy construction.
If your system was installed with this optional Dual Stage Shock Sensor, to disable
the pre-detect stage for one arming cycle anytime after the system is armed, si-
multaneously press the two transmitter buttons shown.
The Horn or Siren will emit a single chirp indicating that the pre-detect stage of the
Shock Sensor is bypassed for that arming cycle.
