Warning Signals" shown later in this manual. If upon disarm, the Horn or Siren
did not beep or chirp two times, refer to the section entitled "Eliminating The
Arm/Disarm Beeps or Chirps".
INTRUSION WARNING SIGNALS:
The system will warn you if an intrusion attempt has been made in your absence.
Upon disarm, the Horn or Siren will beep or chirp four times and the parking lights
will flash three times, indicating that the security system had been triggered. Enter
the vehicle and before turning on the ignition switch, observe the LED flash pattern.
If the LED is flashing 1x pause, 1x pause, etc... then an intrusion attempt was
made and detected by the shock sensor.
If the LED is flashing 2x pause, 2x pause, etc... then an intrusion attempt was
made and detected by opening of the hood or trunk.
If the LED is flashing 3x pause, 3x pause, etc... then an intrusion attempt was
made and detected by opening of the vehicle doors.
If the LED is flashing 4x pause, 4x pause, etc... then an intrusion attempt was
made and detected by any additional sensors connected to the vehicle.
All of the above LED patterns are intended to give you the opportunity to inspect
area's of your vehicle for possible damage. These LED warning patterns are
stored in the system's memory and will be erased when the ignition key is turned
to the on position.
VALET OPERATION:
The valet switch allows you to temporarily bypass all alarm functions, eliminating
the need to hand your keychain transmitter to valets or garage mechanics. When
the system is in the valet mode, all alarm features are bypassed. However, the
panic feature, as well as the optional door lock/unlock circuit, will remain operational.
To enter the valet mode:
Start with the alarm disarmed and valet switch in the off position.
Turn the ignition switch to the on position.
Turn the valet switch to the on position.
The dash mounted LED will turn on solid indicating that the valet mode has been
successfully entered.
To return to the normal mode of operation, move the valet switch to the off posi-
tion any time the ignition switch is in the on position.
MANUAL OVERRIDE OPERATION:
In the event that you lose your transmitter or if the transmitter battery fails while
the system is in the armed mode, it will be necessary to override the system to
operate the vehicle. In this situation, to override and disarm the system:
Start with the valet/override switch in the off position. Open the vehicle door with
the door key. (The alarm will sound). Turn the ignition switch to the on position.
"Within 10 seconds" turn the valet/override switch to the on position.
The alarm will disarm and the vehicle can now be started and operated normally.
Always remember to move the valet/override switch to the off position to insure
the vehicle remains protected.
-6-
