background image

ARMING THE SYSTEM

, Active:

Turn the engine off, exit the vehicle and close all doors, hood, and trunk.
Press and release the transmitter button with the lock icon on it.

The parking lights will flash once, the Horn or Siren will beep or chirp once, and
the dash mounted LED will begin to flash slowly indicating that the system is
armed. If you have the optional door lock/unlock circuit installed, the doors will lock.

NOTE:

If the Horn or Siren beeped or chirped three times, this indicates that a

door, hood or trunk has been left ajar. Simply closing that open entry point will

provide full protection. If the Horn or Siren did not beep or chirp upon arming of
the system, then the beeps or chirps have been turned off. Refer to the section
entitled "Eliminating the Arm/Disarm Beeps or Chirps" shown later in this manual.

SILENT ARMING,

Active:

Turn the engine off, exit the vehicle and close all doors, hood, and trunk.

Press and hold the transmitter button with the lock icon on it for 2 seconds.
The parking lights will flash once, and the dash mounted LED will begin to flash
slowly indicating that the system is armed. The Horn or Siren will not beep or

chirp. If you have the optional door lock/unlock circuit installed, the doors will
lock.

NOTE:

If the Horn or Siren beeped or chirped three times, this indicates that a

door, hood or trunk has been left ajar. Simply closing that open entry point will
provide full protection.

ARMING THE SYSTEM,

Passive (Automatic):

If the passive (automatic) arming feature has been selected:
Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
The dash mounted LED will begin to flash rapidly indicating that the 30 second

passive arming cycle has begun. If the LED does not begin to flash rapidly, a
door, hood or trunk has been left ajar. Simply closing that open entry point will
allow the arming cycle to begin. Any entry point opened during the 30 second

arming cycle will suspend the arm timer. When all entry points are closed, the
arm timer will begin again.
At the end of the 30 second arming cycle, the parking lights will flash once, the
Horn or Siren will beep or chirp once, and the dash mounted LED will begin to
flash slowly indicating that the system is fully armed. If the Horn or Siren did not

beep or chirp upon completion of the arming cycle, the beeps or chirps have been
turned off. Refer to the section on "Eliminating the Arm/Disarm Beeps or Chirps"
shown later in this manual. Passive door locking is a selectable feature. If you

have the optional door lock/unlock circuit installed, the doors may or may not lock
dependent on the setting of this selectable feature at time of installation.

PROTECTION WHILE THE SYSTEM IS ARMED:

Opening any of the protected entry points while the system is armed will immediately

cause the alarm system to trigger. The Horn or Siren will sound, and the lights

will flash. If the optional interior illumination circuit has been added, the interior

-4-

Содержание Pursuit PRO-9744WOS2









Отзывы: