Page 4
SILENT DISARMING
1. As you approach the vehicle, press and hold the ARM / DISARM button on the keychain
transmitter for 2 seconds.
Red dash mounted L.E.D. turns off.
If passive arming was selected during the installation, then the L.E.D. will
start flashing rapidly, indicating that the system is re arming automatically.
Open any door to suspend the automatic arming.
Parking Lights flash two times.
If the parking lights flashed three times, then the alarm was triggered in
your absence. Before turning the key on, examine the L.E.D. to identify
which zone was triggered.
Siren/Horn does not sound.
If the siren and or horn sounds 4 chirps, then the alarm was triggered in
your absence. Before turning the key on, examine the L.E.D. and refer to
the INTRUSION WARNING SIGNALS section of this manual to identify
which zone was triggered.
Doors Unlock - Optional
Courtesy Light - Optional
Interior courtesy lights turn on for 30 seconds, or until the ignition key is
switched on.
INTRUSION WARNING SIGNALS
This system will inform you if an intrusion attempt has occurred while you were away from the
vehicle. If an intrusion attempt has occurred, the siren/horn will chirp 4 times and the parking
lights will flash 3 times when disarming the system. Enter the vehicle, and observe the red dash
mounted L.E.D. to identify which zone was triggered.
If the L.E.D. is flashing one time...pause...one time...pause...etc., then an intrusion
attempt was made to the optional shock sensor, or an accessory triggering device that
may have been added to the system.
If the L.E.D. is flashing two times...pause...two times...pause...etc., then an intrusion
attempt was made to a hood or trunk pin switch that was added to the system, or to a
light activated entry point if the alarm was installed using the voltage sensing feature.
If the L.E.D. is flashing three times...pause...three times...pause...etc., then an intru-
sion attempt was made through one of the vehicle’s doors.
These intrusion warning indicators are stored in the system’s memory, and will only be erased
when the ignition key is turned on.