PROGRAMMING TRANSMITTERS:
It is important to remember that during programming, each individual step of
the procedure must be executed within 15 seconds of the previous step. When
the 15 second time limit is allowed to expire, the system will automatically exit
program mode. This is indicated by a long "chirp" from the siren.
Additionally, any time the ignition key is turned off while programming, the
system will immediately exit program mode. This is also indicated by a long
"chirp" from the siren.
TO PROGRAM ADDITIONAL TRANSMITTERS:
Note: The programming information described below assumes that the default
transmitter is being used and the Lock/Unlock button is one and the same. If
you have the optional transmitter with a separate Lock and Unlock button, use
letter "B" reference below for programming.
Also, where indicated that the siren will emit a long chirp tone, the optional horn
may be connected, in which case either or both the horn and siren may sound.
1. (a) Enter the vehicle, and turn the ignition key to the "on" position.
(b) Enter the vehicle, and turn the ignition key to the "on" position.
2. (a) Press and release the valet/bypass push button switch 3 times.
(b) Press and release the valet/bypass push button switch 3 times.
3. (a) The dash LED will flash one time, and the siren will "chirp" 1 time
indicating the system is ready to accept programming for channel 1,
Arm/Disarm, Lock/Unlock and Panic.
(b) The dash LED will flash one time, and the siren will "chirp" 1 time
indicating the system is ready to accept programming for channel 1,
Arm/Lock and Panic.
4. (a) You can assign the Lock/Unlock, Arm/Disarm button, by pressing and
holding the lock/unlock button until the siren emits a long chirp tone.
The chirp tone confirms that programming of channel 1 was successful.
Up to 4 transmitters can be programmed, press and hold the selected button
of each additional transmitter until the chirp tone is heard, or press and release
the valet push-button switch two times to advance to step #8.
(b) You can assign the Lock/Arm button by pressing and holding the lock
button until the siren emits a long chirp tone.
The chirp tone confirms that programming of channel 1 was successful.
