15
Installation
Connection of the MATCH M 2.1AMP to the
signal source:
Caution:
Carrying out the following steps will re-
quire special tools and technical knowledge.
In order to avoid connection mistakes and / or dam
-
age, ask your dealer for assistance if you have any
ques tions and follow all instructions in this manual
(see page 11).
It is recommended that this unit will be installed by
an authorized MATCH dealer.
1. Configuring the mono or stereo operation
The M 2.1AMP can be operated as 1-channel
(Mono Mode) or 2-channel (Stereo Mode) am-
plifier. The Mono Mode is activated by default.
To activate the Stereo Mode the device has to
be opened and a jumper must be removed.
Therefore dismantle the side panel where the
Line Input
is located by removing the two Phil
-
lips screws and pull out the bottom plate side-
ways. Now you have access to the jumper.
Mono Mode: Jumper plugged
Stereo Mode:
Jumper removed
1
MicroFit connector – this will be connected to the
Line Input
of M 2.1AMP.
2
RCA / Cinch connectors – these will be connected to the pre-amp
/ lowlevel- / RCA / Cinch outputs
of a DSP / DSP amplifier
.
Fig. 1:
Line Input connection cable
1
2
Fig. 2:
Power Input plug
Plug top side
3
+12 V – For connecting the +12 V power supply cable.
4
GND – For connecting the ground cable.
3
4
