Audiolab 8000AP, Инструкция пользователя

Страница: 20 / 24

Sound is poor quality / distorted
The sound does not co-incide with the picture
The front panel display is blank
Sound comes from only some of your loudspeakers
Check that:
Check that:
Check that:
Check that:
• all cables are making good connections. If necessary,
switch off the power, then withdraw the connector and plug it
back in again, then switch on the power.
• you have set the speaker type to suit your system.
• Night Mode is not enabled.
• if you are using a flat screen TV the Lip-Sync is adjusted
correctly.
• The display is not turned off. Press the display display key on
the remote control.
• the 8000AP is set up to use all the speakers in your system.
• a suitable surround sound source is selected and playing.
• if you are playing a digital source, the player is outputting
multi-channel data.
• the display indicates that the disc is multi-channel .
• you have not selected the ‘stereo’ down-mix mode.
• the speaker balance is correct.
• all amplifiers are switched on.
Until you are familiar with the operation of your 8000AP,
you may experience occasional difficulties. This guide
will help you overcome the most likely issues.
Check that:
Check that:
Check that:
Check that:
Check that:
No lights on the unit
No response/poor response to handset commands
No on-screen display
No sound
The Mute function does not work
• the mains lead is plugged in and that the outlet to which it is
connected to is switched on.
• the mains switch on the 8000AP is ON.
• the 8000AP is switched on.
• there are fresh batteries in the remote control.
• the 8000AP’s display window is visible and you are pointing
the remote control towards it.
• your television is on and switched to display the output from
the 8000AP.
• the correct video input is selected at the TV.
• the correct TV system is enabled
• the correct source is selected.
• the volume is turned up to a reasonable level
• the output is not muted.
• your source and power amplifier(s) are connected correctly
and switched on.
• the volume has not been turned fully down to the mute
position.
(see Page 17)
10 Troubleshooting :
Page 18