AudioControl Maestro M8, Руководство по пользовательскому опыту

Страница: 42 / 50

®
42
M
aestro
M8™
t
roublesHootIng
Troubleshooting Common Problems
General
There are no lights on the Maestro M8
ü
Pressing any button or the Standby button on the front panel should wake
the Maestro M8.
ü
Verify that the power cord is plugged into a live AC outlet.
ü
Verify that the rear panel Power switch on the Maestro M8 is “On”.
The main front panel display is blank
ü
Press the Display button. This button controls the display brightness and
also allows you to turn the display off entirely.
The main zone changes while selecting sources from Zone 2
ü
Change the Zone 1 Control option in the Zone 2 Configuration Menu to
Off.
Video
No video/picture
ü
Verify your video display or projector is turned on and set to the correct
input for the Maestro M8. Press the Menu button on the Maestro M8 and look for
the Main Menu to show on the video display.
ü
Verify the correct input on the video display is selected for the output of the
source (i.e. Component Video if the output of the DVD player is Component).
ü
Verify the Video Input assignment configurations. Make certain that the
correct video input is assigned to the source you are playing.
ü
If at any point you need to reset the video output resolution and frame rate
to the default setting, push and hold the “Select” button for 3 seconds.
ü
If you are using a Blu-ray player with a 1080p/24 fps (frames per second)
format, you will want to confirm the output format of the player you are using
matches with the input format of your display device. The Maestro M8 supports
both 1080p/24 fps (frames per second) and the more commonly used 1080p/60 fps
video formats. To properly utilize the 1080p/24 format you will want to make sure
that the source device (i.e. Blu-ray player) and the display device (i.e. projector
or TV) are both capable of supporting this format. In the Video Output section of
the Setup menus, set the Output Resolution of your Maestro M8 to 1080p (not
Preferred) and make sure that the Frame Rate is set to Auto. Failure to do any of
the above could result in no image.