12
Concert XR series
HTR-3 Remote Control
The supplied remote control is an
eight device “universal” IR remote
controller with back-lit gum-drop
buttons. You can set up the remote
for full control of your AudioControl
receiver plus various AV sources and
displays via the extensive library
of device codes found on our web
site - www.audiocontrol.com. The
remote is also a “learning remote”
which means that you can capture
the codes of your existing remotes
if you find that the library does not
contain the codes for your device.
Being that the remote can control
your Concert XR series as well as
many other AV sources and displays,
many of the buttons have more than
one function, depending on which
device/source or mode you are using
the remote in. We will ease into
the complexities of the remote’s
multi-function modes after a quick
description of the basic features
below.
Please note: Device code library,
instructions on programming
the remote and more control
and automation documents
are available on our website at:
www.audiocontrol.com/support
18. VOLTAGE SELECTION - The Concert
XR series is designed to operate with
either 110-120 volt or 220-240 volt line
voltages.
WARNING: Before the unit is turned
on, make sure that this switch is set to
your local AC power voltage.
19. AC INPUT - Connect the supplied AC
power cord securely to this input. Plug
the other end into an AC mains outlet
of the correct voltage rating for your
unit. They are either 100 -120 VAC (50
– 60 Hz) or 220 – 240 VAC (50 – 60 Hz);
look at the check box to see how your
unit has been configured.
20. FAN - A fan is used to cool down the
internal power amplifiers. Caution:
Do not block the fan or any of the
ventilation slots. There should always
be plenty of good ventilation to cool
the unit.
Control of Your Concert XR series
