AudioCodes TP-6310, Руководство по установке оборудования

Страница: 56 / 70

SIP Hardware Installation Manual 56 Document #: LTRT-94701
3000 Series Gateways & Media Servers
¾ To connect the GbE interfaces, take this step:
„ On the RTM-8410, connect the LAN cable to each of the GbE port connectors, using
Category 5 LAN cables with RJ-45 connectors (refer to the figure below):
Table 3-6: RJ-45 Connector Pinouts
Pin FE Signal GE Signal
1 TX DATA+1 Tx A+
2 TX DATA- Tx A-
3 RX DATA+2 Rx B+
4 N/C Tx C+
5 N/C Tx C-
6 RX DATA- Rx B-
7 N/C Rx D+
8 N/C Rx D-
Figure 3-12: RJ-45 LAN Ethernet Network Port and Connector
3.3.4 Connecting the Alarm Terminal Block Closures
The Alarm Terminal Block closure on the PEM module contains four groups of terminals for
connecting external Telco alarm devices according to Critical, Major, and Minor severity
levels. Devices can be controlled using the Common (COM) and Normally Open (NO)
method. The IN connector is for user-defined connections (currently not supported).
The PEM module provides three dry contact relays for connecting to Telco alarm
equipment. Each alarm output is a dry relay contact. Each contact can withstand up to a
maximum of 30 VDC when open and carries up to a maximum of 2 A DC when closed.