AudioCodes Mediant 9000, Руководство по установке оборудования

Страница: 22 / 50

Mediant 9000 SBC
Hardware Installation Manual 22 Document #: LTRT-41659
4.2 Connecting to Power
This section shows how to connect the device to the power supply. The device can be
connected to an AC or DC power source.
You can connect both Power Supply modules (1 and 2), for 1+1 power load-sharing and
redundancy. Each module provides a power socket on the device's rear panel. If both
power modules are used, make sure that you connect each one to a different power supply
socket.
Note: When connecting both Power Supply modules, the two AC power sources must
have the same ground potential.
Warning: The device must be connected (by service personnel) to a socket-outlet with
a protective earthing connection.
4.2.1 Connecting to AC Power Source
The AC power supply specifications are listed in the table below.
Table 4-1: AC Power Supply Specifications
Specification Value
Input requirements -
Rated input voltage 100 V AC–240 V AC
Rated input frequency 50 Hz or 60 Hz
Rated input current 3.5 - 8.5A
Rated input power

843 W at 100 V AC input

811 W at 200 V AC input
Btus per hour

2878 at 100 V AC input

2769 at 200 V AC input
Power supply output -
Rated steady-state power

750 W at 100 V to 120 V AC input

750W at 200 V to 240 V AC input
Maximum peak power

750W at 100 V to 120 V AC input

750W at 200 V to 240 V AC input
Warning: Use only the AC power cord supplied with the device.
ご注意
本製品に添付の電源ケーブルは、
Mediant 9000
に専用設計されているため、汎用性が
ありません
.
本電源ケーブルを他の機器に使用されないよう、ご注意ください
.