AudioCodes Mediant 9000, Руководство по установке оборудования

Страница: 32 / 50

Mediant 9000 SBC
Hardware Installation Manual 32 Document #: LTRT-41659
Note: Use the Tab key to auto-complete partially entered commands.
7. At the prompt, type the following commands to configure the IP address, prefix length
and default gateway:
(network-if-0)# ip-address 10.4.212.155
(network-if-0)# prefix-length 16
(network-if-0)# gateway 10.4.0.1
(network-if-0)# exit
(config-voip)#
8. At the prompt, type
exit
to complete the
network-if
configuration:
(network-if-0)# exit
9. If Mediant 9000 is connected to the IP network that uses VLAN ID (for example, VLAN
ID 10), type the following commands to configure it (otherwise skip to step 10):
(config-voip)# interface network-dev 0
(network-dev-0)# vlan-id 10
(network-dev-0)# tagging tagged
(network-dev-0)# exit
10. At the prompt, type
exit
to complete the configuration:
(config-voip)# exit
11. At the prompt, make sure that port #1 is connected (Link is UP) using the
show voip
ports
CLI command as described in Section 4.4.1 on page 29 .
Port #1 is mapped to network-if-0 by default.
12. At the prompt, type
reload now
to reset the product and activate the new
configuration:
# reload now
After the Mediant 9000 restarts, connect to its Web interface to continue the provisioning. See
the
Mediant 9000 User's Manual for details.
Figure 5-2: Web Interface