Audio RMS 2020, Руководство пользователя

Страница: 19 / 31

88
19
Audio output
Provides microphone-level balanced outputs from the
two receivers.
Power input
Allows the receivers to be powered via an external DC
supply.
Antennae
Connects the Rx1 and Rx2 antennae.
Front panel
The indicators and controls of each receiver are visible
from the top of the RK 2 rack. For more information see
DX 2020 Receiver , page 7.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Setting up the RK 2
To set up the RK 2 in conjunction with one or two DX
2020 receivers:
• Fit the receivers into the RK 2.
• Connect external power.
• Connect the antennae.
These steps are explained below:
Fitting the receivers
To fit the individual receivers into the RK 2 first remove
the plastic plate covering the multipin connector on
each receiver. Orientate the receiver to ensure correct
alignment of the Lemo and multipin connectors. Slide
the receiver in, and push firmly home. Do not use
excessive force.
Connecting power
Connect power to the four-pin Hirose connector via the
cable provided (900–122). Alternatively the RK 2 can be
powered via either of the six-pin Lemo connectors.
The RK 2 has a built-in regulator and can accept power
in the range 9–15V DC. It is over voltage and reverse
power protected; if reverse power is accidentally
applied disconnect the supply and allow a few moments
for the electronic fuse to reset.
Rk2 Minirack