88
16
These steps are explained below:
Fitting the battery
Unscrew the battery compartment and insert a DL123A
type Lithium battery with the positive end uppermost.
Replace the battery compartment.
Selecting the operating frequency
Set the F1/F2 switch to select the operating frequency.
The two available operating frequencies are marked on
the label above the battery compartment.
Connecting the antenna
Screw the antenna directly into the base of the battery
compartment. For short-range work the antenna can be
omitted, as the battery compartment acts as an antenna.
Switching on
To switch on unscrew the locking ring, and then screw
the battery compartment up tight so that the amber
operation indicator lights up. Then screw up the locking
ring to prevent the user from inadvertently unscrewing
the battery compartment during use.
When not in use the power should be locked off by
unscrewing the battery compartment and then
tightening the locking ring. Remove the battery if the unit
is not to be used for a while.
Setting the gain
The gain control should be adjusted to suit your
particular requirements. Select the gain position such
that the overload indicator does not illuminate during
normal speech.
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
Holding the HX 2000
The HX 2000 should be held by the main tube, which is
finished in gloss black to minimise handling noise.
Avoid touching the areas finished in matt black, and in
particular the battery compartment as this forms part of
the antenna.
HX 2000 Hand Held
Transmitter
The HX 2000 handheld transmitter does not transmit the
low TX battery level, consequently the low TX battery
indicator on the receiver will remain on. This is not a
fault.
Содержание RMS 2020
Страница 1: ......