English |
Deutsch
CLASSIC Line
Unpacking and Assembly
1.
Lay the box down on the floor
j
. Carefully open the packaging on the long side where it has been taped up,
preferably using a pocket knife or kitchen knife.
2.
Remove the „Welcome to the Audio Physic Family“ package
k
.
3.
Now remove the loudspeaker together with its protective foam pads from the box
l
.
Make sure that you do not
touch the drivers
when removing and handling the loudspeaker as this may cause irreparable damage to the drivers.
4.
Between the loudspeakers there is a drilling template made of cardboard. It facilitates the mounting of the
CLASSIC On-Wall unit on the wall.
5.
Now remove the top foam cover and carefully slide down the protective foil so that you can easily remove the
loudspeaker.
6.
Our CLASSIC On-Wall models are fitted with a solid front panel without fabric when delivered from our factory.
If you wish, you can easily exchange this panel for the panel covered in fabric that is also enclosed with your
loudspeaker to suit your tastes. To do so, simply use your fingers to carefully lift off the fitted panel.
Please ensure
that you do not touch the drivers when doing so.
Once you have removed the panel, place the fabric-covered
panel in its position and softly push it in into place until it is flush with the loudspeaker cabinet. You do not
need to worry about any limitations or loss of sound details when using either of the panels.
7.
The loudspeakers also include an affixing template for the AUDIO PHYSIC logo on the speakers. This allows you
to affix the logo easily and precisely onto the loudspeakers.
Connecting the Loudspeakers
Your new loudspeakers are electrically configured so they can be readily operated via both a stereo amplifier or a receiver
such as the amplifier integrated in a television set – to the extent that the TV set is equipped with the appropriate
loudspeaker outputs. It‘s important here to remember to deactivate the loudspeakers of the television set. Please refer
to the relevant instructions in the user manual of your television set.
The CLASSIC On-Wall loudspeakers are fitted with particularly high-quality connectors from the nextgen™ range made
by the specialist manufacturer WBT (see the image below). These connectors feature a
torque indicator
that helps you
to connect cables with spades. They accept both spades and banana plugs. Loose cable strands oxidise easily and are
not suitable for a permanently high-quality listening experience.
1.
Please switch off all devices on your hi-fi system or TV prior to beginning
to connect the loudspeakers.
2.
If you are using a loudspeaker cable with spade connectors, turn the screw
clamps to the left until you can easily slide the spades into the openings
at the side. Push the spades into these openings and
turn the screw
clamps to the right until you hear a clicking noise -
this is the torque
indi
cator.
Now turn the clamps until they are hand-tight, which will normally
be the case after a few more ‚clicks‘. After this point, you can indeed tighten the clamps even more, but this will
not improve the results. In the worst case scenario, further tightening the clamps may lead to damage to the surface
structure of the spade connectors.
14
j
k
l
