Audio Authority SF-16M, Инструкция по установке и эксплуатации

Страница: 28 / 36

28 SF-16M Matrix Amplifier Installation and Operation Guide
BUS
IN
BUS
OUT
ASSIGN
CHANNEL
STEREO
MONO 1
MONO 2
MIX
OVER-
RIDE
BUS
FLEXPORT
761-391
ON
ON
MOMENTARY
TERM. ON
OFF
OFF
TOGL.
OFF
SWITCH
GAIN
MIN
MAX
BUS
IN
BUS
OUT
ASSIGN
CHANNEL
DUAL M
MONO 1
MONO 2
INPUT
MIX
OVER-
RIDE
BUS
PWR
FLEXPORT
761-392
MIC
ON
ON
MOMENTARY
TERM. ON
PHANT. OFF
LINE
OFF
OFF
TOGL.
OFF
ON
SWITCH
GAIN
MIN
MAX
Appendix B: Firmware Update Procedure
The latest version of firmware is available from our website on the SF-16M product page.
Learn more: www.audioauthority.com/sonaflex_tips.
1. Copy the latest firmware file onto a USB drive.
2. Insert the drive in the USB port on the rear panel of the SF-16M.
3. Press the menu key and navigate to the firmware update menu item.
4. Follow the prompts and select the firmware file.
5. After a short delay the SF-16M reboots and performs the firmware update.
6. Once the update has finished, the SF-16M reboots and resumes operation with the new firmware version.
Appendix C: SF-16M Rack Mounting
The SF-16M is designed so that it may be installed either on a shelf or
in a standard 19-inch equipment rack. If rack mounting, remove the
feet and the cover screws adjacent to the front panel of the unit. Reuse
the cover screws to mount the rack adapters supplied with the SF-16M.
Be sure to place a spacer under the adapters at every screw location.
Secure the SF-16M to the rails of the equipment rack with the screws
supplied, and use appropriate chassis supports, such as Middle Atlantic
CSA Series.
FlexPort Module “Override” Button
The purpose of the front panel override button is to switch designated SF-16M outputs to a FPM input.
Learn more: www.audioauthority.com/sonaflex_tips. A typical example is an audio mixer, connected to a
FPM-X in a conference room. When the override button is pressed, designated outputs switch over to the
audio mixer for the duration of the override. When the override button is pressed again, all affected outputs
will switch back to the input source prior to override. Audio override is based on two key settings:
1. FPM dipswitch settings, previously configured above.
2. SF-16M audio override settings, programmed using the SF-16M PC configuration software (see page 22 or view the
online video Override tutorial).
Audio Override with “Mix” Option Enabled
In some cases it may be desired to mix two FPM
module inputs together upon audio override.
An example would be a classroom where both
a microphone and an audio presentation need
to be heard simultaneously. To acheive this
function, first daisy chain two FPM modules and
wire back to the SF-16M. Set one FPM as “Mono
1”, and set the other as “Mono 2”. Both FPM’s
must have the “Mix” dipswitch set to On.
SF-16M
FlexPort
Input
Figure A-4
Figure C-1
SONAFLEX
VIDEO
TUTORIALS