Audio Analogue Rossini 2.0, Руководство пользователя

Страница: 12 / 16

12
Specifications
Parameter Measurement conditions Value
Channels: - 2
Maximum output voltage: - 1.9Vrms
Frequency response: - 20Hz-20kHz +0/-3dB
Noise level Band limits 0Hz-20kHz -120dB under 1Vrms
Signal/noise ratio 22Hz-22kHz 98dB
Power requirements: - 230V 50-60Hz or 115V 50-60Hz
Power consumption: - 40VA
Specifiche Tecniche
Parametro Condizioni di misura Valore
Numero di canali: - 2
Tensione max di uscita - 1,9Vrms
Risposta in frequenza - 20Hz-20kHz +0/-3dB
Livello di rumore Limiti di banda 0Hz-20kHz -120dB sotto 1Vrms
Rapporto segnale/rumore 22Hz-22kHz 98dB
Alimentazione: - 230V 50-60Hz oppure 115V 50-60Hz
Assorbimento: - 40VA
TROUBLESHOOTING
Symptome Cause Remedy
Unit is in stand-by mode
Push STBY button on the remote
controller or any button on the front panel
Power cord incorrectly plugged
Make sure the power cord is correctly
plugged into the wall outlet Display is off
No sound
Burned-out fuses
Check fuses in the fuse panel (after
unplugging the power cord from the wall
outlet) above the IEC inlet and replace
them with new ones of the same type
Faulty or incorrectly plugged connectors
between Rossini CD Player and the
amplifier
Check cords and their connection
Display is on
No sound
Incorrectly selected source on the amplifier
Check that Rossini CD Player is correctly
selected through the amplifier inputs
CD player is on but the display is off
Faulty front panel
Contact your Audio Analogue retailer for
connections check and front panel
substitution
No battery/ worn-out battery Place/replace battery (2 ‘AAA’ batteries)
Remote controller doesn’t work
You’re standing too far or on an exceeding
angle from the front panel
Get closer to the unit or reduce angle
The unit is on but there is no sound Worn-out or damaged fuse
Contact your Audio Analogue retailer for
fuse check and substitution
If the suggested remedies should not work or the problem is not shown in the list above, please contact your local Audio
Analogue retailer.