Audi Genuine Accessories 80A.071.128, Руководство по установке

Страница: 14 / 18

– Insert the tensioning belt -11- in the tightener -5- and align it
centrally.
Caution
Ensure that there is a gap between the tensioning belt -11-
and the roof of the vehicle — risk of roof damage!
– Tighten the tensioning belt -11- evenly on each side.
– Install the second tensioning belt -11- following the same
procedure.
– Shake the bicycle to check that it is securely seated.
– Use the key -4- provided to close the lock on the rotary knob
-8-.
WARNING
Check that the bicycle rack and the bicycle to be trans-
ported are securely attached:
◆
Before the start of every journey,
◆
After approx. 10 km of the journey,
◆
Approx. every 500 km on good roads,
◆
Frequently on poor roads (due to vibration),
◆
Regularly to make sure that there has been no move-
ment/displacement.
If the bicycle rack and bicycle are not checked to make
sure that they are secure and to check whether any fix-
tures need tightening, they could work loose and parts
might be lost, even if installation was carried out properly
— risk of accident!
Observe the safety notes for the bicycle rack
⇒
"Safety
notes" on page 2.
– Calculate the new height of the vehicle with the bicycle at-
tached.
WARNING
Note the altered vehicle height. Pay particular attention
to:
◆
Low-hanging branches
◆
Passages with reduced head-room clearance
◆
Entrances to garages with reduced head-room clear-
ance
◆
Height restrictions in multi-storey car parks and un-
derground car parks.
Installation instructions - Bicycle rack
Edition 01
12 5 Installing/removing the bicycle rack and bicycle