ATX DVIS, Руководство по установке и эксплуатации

Страница: 77 / 112

CHAPTER 12: IP OUTPUT TAB - CONFIGURATION
MDU Solutions
®
– DVIS/DVISm - Digital Video Insertion System & Mini Digital Video Insertion System - Installation & Operation Manual 12-1
IP OUTPUT
12. IP Output Tab - Configuration
This chapter is about the configuration of the Gigabit Ethernet (GbE) card shown in Figure 12-1. The GbE option supports
transmission by multicast or unicast of the multiplex created by the encoders. The DVIS platform can simultaneously create
a QAM and IP output with programming duplicated on both. In this case the IP output will be a single multiplex of the created
programs, an MPTS. If the DVIS is configured for IP output only, then SPTS multiplexes may be created for each program.
In IP output only mode the user can select either SPTS or MPTS transmission, but not a mixture of both. See “12.13 Stream
Settings” on page 12-8 to activate the SPTS feature.
FYI: Activation of the ‘IP Output’ tab requires that an IP Card be installed. If there is one installed
check in the “Encoder Settings” on page 6-1 to see that the IP Card is detected. The ‘IP Output’
tab must also be activated on the ‘Mux’ tab. See “Mux” on page 7-1.
FYI: In this guide, reference to DVIS infers DVIS and DVISm unless the model is specifically
stated.
12.1 Chapter Contents
• “Support for VLAN Tagging”
• “Gigabit Ethernet Card Fundamentals”
• “Quick Guide to the Gigabit Ethernet Card”
• “IP Output Configuration”
• “VLAN Settings”
• “GbE Port Numbering”
• “Two VLANs Automatically Created”
• “Stream Settings”
Figure 12-1: GbE Output Module