25 ATTO Technology FibreBridge Installation and Operation Manual
7.1.6 Serial Port configuration commands
The ATTO FibreBridge
TM
serial ports are configured with default settings but may be customized to your
specifications using the CLI commands in this section.
CLI commands are case insensitive (lower case
allowed anywhere).
Commands generally follow a standard format:
[Get | Set] Command [Parameter 1 | Parameter 2]
followed by the return or enter key
SerialPortBaudRate
Configures/reports the baud rate for the FibreBridge RS-232 serial port. The number of data bits per character is fixed at 8 with no parity.
Limits: 2400, 9600, 19200, 38400, 57600, 115200
Default: 11520
Actions: set SerialPortBaudRate [2400 | 9600 |19200 |
38400 | 57600 |115200]
Information: get SerialPortBaudRate
SaveConfiguration
SerialPortEcho
Enables/disables/reports the echoing of keyboard input. When enabled, all non-control character keyboard input is output to the display.
Limits: Local ASCII terminal (or terminal emulator) echo
settings should be set to disabled while using
SerialPortEcho enabled
Default: enabled
Actions: setSerialPortEcho [enabled | disabled]
Information: get SerialPortEcho
SaveConfiguration Restart
SerialPortHandshake
Configures/reports the data handshaking method used to control the flow between the transmitter and receiver using hardware flow control, software
flow control (Xon/Xoff)or no flow control.
Limits: hard (hardware flow control), xon (software flow
control) or no flow control (none)
Default: no flow control (none)
Actions: set SerialPortHandshake [hard | xon | none]
Information: getSerialPortHandshake
SaveConfiguration
SerialPortStopBits
Configures/reports the number of stop bits per character for the FibreBridge RS -232 serial port. The number of data bits per character is fixed at
8 with no parity.
Limits: 1 or 2
Default: 1 stop bit
Actions: set SerialPortStopBits [1 | 2]
Information: get SerialPortStopBits
SaveConfiguration
Содержание FibreBridge 1190E
Страница 2: ......
