ATTO Technology FibreBridge 1190E, Инструкция по установке и эксплуатации

Страница: 11 / 48

6
FibreBrid
g
e 1190E
Ethernet port
The 10/100 Base T Ethernet port supports SNMP-
and Telnet-based monitoring and management
through a command line interface or menu
system.
Serial port
The RS-232 serial port provides support for
remote monitoring and management through a
command line interface or menu system.
Serial/Ethernet RJ45 port
The RJ45 port may be used for either
serial or Ethernet connections depending
on the jumper settings and cable. The
factory sets the jumpers in a serial
configuration across the top and middle
rows of the selector header.
To enable an Ethernet configuration,
move all the jumpers in the selector
header to the middle and bottom rows.
Attach a standard Ethernet cable.
If using the RJ45 in a serial
configuration, create a serial cable
connection with the following pin outs:
LED indicators
➔
FC Activity: LED blinks to show
activity on the Fibre Channel port
(numbered 0). During very high activity,
the LED appears to be steadily lit.
➔
SCSI Activity: shows activity on the SCSI
bus (numbered 0).
➔
Ready: should light after power has been
applied; indicates the board has completed
the initialization process without any
failures and is ready to handle data
transfers.
Exhibit 3-2 FibreBridge 1190E board layout.
Signal Name RJ45 Pin
TX 1
RX 2
Ground 6
Dual stacked
SCSI Connector
Fibre Channel
Connector
SCSl activity
LED
Ethernet / Serial
Port Connector
Fibre Channel
activity
and Ready/Fault
LED
Serial/Ethernet
RJ45 port
selector header
JTAG
Header
Reset
Jumper
RS232 Serial
port header
PCI
Connector
4 Pin Power
Connector