22
Shut down and Cooling
1) Push the “Stop” button to turn off the turbine
and to engage cooling mode. The turbine will
immediately shut off and slow down to 0 %, and
then start a cooling program (will cool down for
app. 7 minutes or until below app. 50˚C).
2) The shut-down procedure will also be initiated
with cooling down, if “0” on the “Power” button
is pushed, however then additionally the
complete unit will turn off after app. 7 minutes.
It is recommended only to use the “Stop” button
to stop the turbine operation.
1) The turbine can be restarted once the display
indicates lower than 4.0K RPM by following the
steps from figure 12.
2) If the Hammer Jet has been completely shut off,
then restart by following the steps from figure
10.
Parking, transport and storage
1) To avoid damage and contamination of the
turbine and other parts, the unit must after
use and when cooled down below
50°C/122°F, be stored and transported in the
dedicated transport and storage box
delivered with the unit.
Figure 22 – Parking, transport and
storage
Figure 20 – Step 9: Shut down and
cooling
Figure 21 – Step 10: Restart of the turbine
