TROUBLESHOOTING HINTS
PROBLEM
SOLUTIONS
Call toll-free number – enter Pager Number and
Security Code, but no response from the PA2001
Verify the Pager Number and Security Code.
Forget to place the Command Code as the last
digit of the Security Code.
Enter the Command Code for Anti-carjacking, but
the Anti-carjacking mode never occurs.
Verify the Pager Number and Security Code you
are using.
Verify you have used the correct Command Code
for Anti-carjacking mode. (This is a selectable
Command Code- See Programming.)
Verify operation of relay configurations as
indicated in the Testing Section.
When the unit is first connected to power, the
horn starts sounding; the lights, flashing.
ATS NASA 2001 will go into “Alarm Mode”
when connected to power. This mode can be
reset by turning “ON” the Ignition Key, and
pressing the Valet Switch once momentarily.
The Door Unlock command is sent but nothing
happens.
Verify the Pager Number and Security Code you
are using.
Verify you have entered the correct Security
Code, followed by user-selected command code
XX for PULSE 1.
A “Latching” command is set, but the activated
command will NOT be turned off.
Verify the Pager Number and Security Code you
are using.
BOTH the “Latching” and “Anti-carjacking”
commands MUST be reset by sending a RESET
command. A RESET command is sent by ending
the Security Code with user-selected command
code as shown on your monitoring service card.
