10
/
22
Do not put things in the air inlet and outlet of the ice maker to prevent ventilation
and heat reject.
Do not install ice machine in direct sunlight.
1) the ice machine should be installed horizontally;
2) the ambient temperature should be 10~43C(50—110F) and the water inlet
temperature is 1~32 C(33—90F)
；
3) For the self-contained ice maker
：
Left and right side must have at
least 5cm gap from the wall and the
top has 1cm gap.
IV.
Operation
1.
Checklist before operation
a) Is ice machine level?
b) Are Water inlet and drain hose connected ok?
c) If there are not water lack with the ice machine?
d) Check the power voltage, if it matches the label on the machine?
2.
operation
1) Freeze cycle
a) Power plug connection
：
the control board led is on
。
b) startup
：
Toggle the switch to the on position, the green led will flash; the
hot gas valve open for 10s, the compressor is energized,
c) ice melt
：
the hot gas valve still keep opening for 20s, then the water
pump running to flush the evaporator for 20s
，
then close the hot gas
valve and water pump and open the drain valve for 15s then close.
d) prechill
（
40s
）：
the compressor is on, and the condenser fan and water
inlet valve are energized, hot gas valve and water pump are closed, thus to
Air inlet
Air outlet
