6
First Steps
Gigaset SL560 / Aton CL303 / SWZ PTT EN / A31008-M1710-F151-1-7619 / starting.fm / 10.7.06
Reception strength:
The display shows the quality of the radio
contact between the base station and
handset:
u
Good to poor:
Ð i Ñ Ò
,
u
No reception:
|
flashes.
Connecting the base station
¤
First
connect the mains adapter and
then
the phone jack as shown below-
and place the cables in the cable
recesses.
1 Underside of the base station (detailed
view)
2 Mains adapter 230 V
3 Phone jack with phone cord
Please note:
u
The mains adapter must be
always
connected
, as the phone will not oper-
ate without mains connection.
u
If you buy a replacement phone cord
from a store, ensure that the phone
jack is connected correctly.
Setting up the handset for use
The display is protected
by a plastic film. Please
remove the protective
film!
Fitting the battery pack
¤
Insert the battery pack at an angle from
the right introducing the lugs into the
cavity first.
¤
Then push the casing from the top,
until the retaining clip on the side of
the battery pack clicks securely into
place in the casing.
Please note:
You must press the retaining clips down in
order to remove the battery pack.
Correct phone jack assignment
1 unused
2 unused
3 a
4 b
5 unused
6 unused
1
3
2
1
1
1
3
2
1
4
5
6
Caution:
Use only the recommended rechargeable bat-
tery pack (page 53). Never use a conventional
(non-rechargeable) battery pack, as this may
cause significant damage to health and prop-
erty. For example, the outer casing of the bat-
tery pack could be destroyed or the battery
pack could explode. The phone could also mal-
function or be damaged as a result of using
batteries that are not of the recommended
type.