Tube Cleaning Instructions
It may be beneficial to clean the tubes to improve performance, by removing dirt and grease from
the tube and mesh where it impairs the ability to generate the plasma for ion creation. The tubes
can be cleaned using an air compressor for a quick clean, or more thoroughly with cleaning
solutions. Be sure to disconnect the system from mains power before performing any cleaning.
Quick-Clean
Disconnect the system from the main power before performing any cleaning. Even if no person or
object is in contact with the system, the air flow may inadvertently cause dirt, debris, water, or other
objects to come into contact with an electrode or both electrodes and create a spark, if the system is
operating. Use a light-duty air compressor for a quick clean of the tubes. Sweep the airflow over the
tubes to remove the loose dirt and debris from the tubes. Clear the areas between and under the
tubes with the air compressor. It may be useful to remove the tubes for improved cleaning. Cleaning
the general area around the tubes to remove dust, dirt, and debris will keep the tubes clean longer.
CAUTION
Do not immerse the tubes in water. Ensure that the tube and mesh are completely dry before
re-installing.
Thorough Clean
Disconnect the system from main power before performing any cleaning. Remove the tubes from
the system.
A more thorough method for cleaning the tubes is to separate the outer mesh from the tube and use
mild cleaning solutions.
1. Remove the mesh from the tube. Grasp the tube, not the end cap, while removing the mesh.
Provide firm but gentle pressure when holding the tube. It may be necessary to gently twist the mesh
in sections working from top to bottom until the entire length is loose enough to pull off.
2. Soak the mesh in a mild soap solution: 30ml of dish detergent per liter of water makes a great
cleanser. Or use running warm tap water in a sink, gently rub the mesh to remove dirt.
3. If you allow the mesh to soak for a few minutes, rinse the mesh thoroughly with water to remove all
traces of soap. Allow the mesh to dry completely.
