9. Check if the safety bolt of the hand brake is not installed (during the transport the bolt must be disassembled
unconditionally). Secure the suspension wheel (bar) in its upper position or disassemble it.
Right coupling conditions (Fig. 3):
The admissible angle deviation during coupling or towing the machine may not exceed the
max. allowed values (lateral inclination 25
∘
, longitudinal inclination 20
∘
. If the allowed angle deviation is exceeded, the strike
of the coupling inner edge against the spherical pin neck may occur resulting in damage of the suspension equipment or the
spherical coupling.
Fig. 1
Fig. 2
Fig. 3
UNCOUPLING THE TOW BAR WITH ISO 50 SUSPENSION
1. Secure the machine against movement using hand brake and wedges.
2. Lower the suspension wheel (bar).
3. Disconnect the electric plug and the safety rope.
4. Open the spherical coupling.
Warning
During coupling/uncoupling of the machine from the towing vehicle and before/during every transport, mind the
operating personnel safety and follow the traffic regulations.
LONG TERM STORAGE PREPARATION
If the machine is to be kept unused in a storage for a longer time period, follow these instructions and place the machine to a
dry dust free place:
∙
If the machine is to be stored outside, put it into a temporary shelter. If left uncovered, the machine would corrode.
∙
Start the machine at least once a week to make sure oil gets to all machine parts.
If it is not possible to start the machine once a week, follow these instructions:
1. Drain the engine oil to a suitable container. Pour new oil to the engine to clean its inside. Run the machine engine for
a short time period. Drain the engine oil again.
2. Recharge the battery and disconnect the ground conductor. Remove the battery from the machine and store it in a dry
place. (Recharge the battery at least once a week.)
3. Drain all the coolant and fuel from the machine.
4. Grease moving parts, such as speed governor and the throttle lever.
5. Seal the engine, air suction, exhaust and other openings with plastic foil to prevent humidity and dust from getting into
the machine.
6. Carry out necessary repairs and keep the machine ready to use.
7. Refill the coolant, engine oil and fuel and start the machine at least once in 3 months during its storage.
At 2020/N
X.11.2016
28
