Hot Water
on Demand
7
Reset
Pump
Testing
THE HEATER TANK MUST BE FILLED UP WITH WATER
BEFORE TURN ON THE ELECTRICITY SUPPLY. THIS
IS TO PREVENT ANY DRY BURNT DAMAGE TO THE
HEATING ELEMENT.
1. Turn on the water supply (
J
) then wait until the water flow
through the Hand shower.
2. Switch on the electrical supply and the Green Led (ELSD) lamp
will turn on (
F
).
3. Turn on the temperature control knob (
E
) to ‘ON’, the red LED
(Heater) lamp will turn on; the hot water will come out in a few
seconds. The higher the temperature indicator position, the
hotter is the shower.
4. The shower might not be enough even at the maximum position
if the incoming water supply from the mains is too cold or the
flow too high. In this case, you can adjust the water inflow in
order to get the desired showering temperature.
5. Check the Built-in ELSD as follow:
• Press the “TEST” button (
B
), the unit should trip and cut off
the power supply,
• All leds lamps should light off.
6. Press the “RESET” button (
C
), the unit should resume normal
function, Green LED lamp should light on. If the above
mentioned procedures prevail, the ELSD is functioning in
normal condition.
7. If shower accessory is available, the height and the direction of
the shower holder is adjustable.
For pump model:
8. Turn on the pump control knob (
D
) to test run the pump.
If the shower is not hot enough, you can adjust the knob (
A
)
to reduce the pump speed until you get the desired shower
temperature.
For power ON/OFF model:
9. After turn ON supply (
J
) and press power ON/OFF button (
G
)
then wait until the water flow through the hand shower.
Testing
A
J
B
C
D
E
F
G
H
