Hot Water
on Demand
5
INCORRECT INSTALLATION
CORRECT INSTALLATION
Plumbing connection
Warning: The outlet of the heater acts as a vent and MUST
NOT be connected to any TAP, CONTROL VALVE OR FITTING
TO THE WATER OUTLET.
1. Connect the stop valve to the water inlet with rubber washer.
Use correct tools to tighten and be careful not to break the
plastic nut.
2. Insert Mesh filter washer then connect the incoming water
piping end to the stop valve (1/2” BSP).
3. Connect the PVC hose and hand shower to the outlet of the
heater; be sure to put in the rubber washer.
4. Hook the hand shower to the slider Rail Holder and adjust to
your ideal position.
•
THE WATER INLET AND OUTLET MUST BE INSTALLED
CORRECTLY, OTHERWISE THE HEATER CAN NOT
FUNCTION.
•
DO NOT USE PLUMBING CEMENT ON CONNECTION. IF
NECESSARY, USE ONLY THREAD OR SEALING TAPE.
Turn on the water mains to drain out all plumbing dirt and to fill up
the heater tank
Check for any water leakage.
(IMPORTANT: This step will
prevent damage to the Heating element).
Fig.5
Fig.6
Danger:
Outlet on the
Left size of unit.
Inlet
Outlet
