Atmel AVR2060, Быстрый старт

Страница: 5 / 14

Atmel AVR2060: BitCloud ZigBee Light Link Quick Start Guide [APPLICATION NOTE]
42004B − AVR − 08/2012
5
5.
To use UART output, attach the serial cable, connected to a PC, to the port marked EXT on a Key Remote
Control board as shown on Figure 2-2 .
Terminal program configuration should be BAUD RATE: 38400; PARITY: None; DATA BITS: 8; STOP BITS: 1;
FLOW CONTROL: Off.
Figure 2-2. Serial cable attached to a Key Remote Control board.
For more details on using RCB and Key Remote Control boards refer to [5] .
2.2.2 Fuse bits settings
The recommended fuse bits settings are shown in Table 2-1 .
Table 2-1. Fuse bits for Atmel ATmega128RFA1.
Option Required value (for 8MHz) Required value (for 16MHz)
BODLEVEL 1V8 1V8
OCDEN Enabled Enabled
JTAGEN Enabled Enabled
SPIEN Enabled Enabled
WDTON Disabled Disabled
EESAVE Disabled Disabled
BOOTSZ Boot Flash size=2048 words
start address=$F800 Boot Flash size=2048 words
start address=$F800
BOOTRST Disabled Disabled
CKDIV8 Enabled Enabled
CKOUT Disabled Disabled
SUT_CKSEL Int. RC osc.;
Startup time: 6 CK + 65ms Transceiver Oscillator;
Starup time 16K CK + 65ms
Resulting bytes
Ext 0xFE 0xFE
High 0x1B 0x1B
Low 0x62 0x77
To quickly test the demo application you may use pre-built application images located in the
Evaluation Tools
directory.