Atmel AVR2060: BitCloud ZigBee Light Link Quick Start Guide [APPLICATION NOTE]
42004B
−
AVR
−
08/2012
10
After the first color light is commissioned, the color scene controller may be brought to the second color light, where
after, receiving the network parameters, it will not start the network once again, but will join the existing network as
another router. The subsequent color lights are commissioned in the same way.
3.3.3.1
Several color scene controllers in a network
A Light Link network may contain more than one color scene controller. Additional controller devices are added using
touch link, which happens between two color scene controllers:
•
Bring a factory new color scene controller to a color scene controller that is already in the network, and press
the PWR button on both devices for more than three seconds
•
Perform touch link between the new color scene controller and each of the color lights
•
Use any of the controller devices to manipulate color lights
Note:
If touch link between controller devices is not performed, pairing a new controller device with a color light that is
already in the network, will cause the color light to leaving this network, and form a new one.
3.3.4 Controlling a light device – all commands
on the next page depicts the key remote board’s keyboard and all commands that can be sent with the
buttons from the color scene controller.
Each button may be used to send up to four commands. What command is sent by pressing a button, depends on
whether buttons R+ and R- are also pressed or not as shown in
Table 3-2. Alternating a command by holding R+ and R- buttons.
Number of command
R+ and R- buttons state
First command
Both are not pressed
Second command
R+ is pressed, R- is not pressed
Third command
R+ is not pressed, R- is pressed
Fourth command
Both are pressed
For example, to send a Toggle command press the L+ button while holding both the R+ and R- buttons pressed.
For buttons 1, 2, and 3:
if a button is pressed for more than three seconds (when both R+ and R- are not pressed) a
Store Scene command is sent; if a button is pressed for less than three seconds a Recall Scene command is sent.
