AT-UHD-SW-510W
47
The Web GUI
Connect Mode
Select this option to allow the AT-UHD-SW-510W to connect to an available
wireless network.
SSID
The name of the wireless network to which the AT-UHD-SW-510W is
connected. Click the
Pick
button to select the desired wireless network.
Password
Enter the password, required to connect to the AT-UHD-SW-510W. The
password must be 8 characters in length. The default password is
88888888
.
Status
Displays the connection status.
State
Description
Connected
The AT-UHD-SW-510W is connected to the
wireless network.
Not Connected
Unsuccessful connection. Check to make sure
the password was entered correctly. This state
will also occur if the wireless network, to which
the AT-UHD-SW-510W is connected, is taken
offline.
Unknown
The network state is unknown. This message is
displayed if the AT-UHD-SW-510W has not been
configured to connect with a wireless network.
Ethernet tab
Click this tab to configure wired network settings on the AT-UHD-SW-510W.
By default, the AT-UHD-SW-510W is set to DHCP mode, allowing a DHCP
server (if present) to assign the unit an IP address.
If a DHCP server is not found within 15 seconds, then the unit will be placed
in Auto IP mode and use a self-assigned IP address within the range of
169.254.xxx.xxx
.
When
Mode
is set to
DHCP
, the
IP Address
,
Network Mask
, and
Gateway
fields will automatically be populated by the AT-UHD-SW-510W, using a
DHCP server, and cannot be modified.
Save
Click this button to connect to the specified wireless network (SSID).
Cancel
Resets the Wifi and Ethernet settings to factory-default settings, then
displays the Wifi tab.
Reset to Factory Default
Resets the networking subsystem to factory-default settings.
