Atlona AT-GAIN-120, Руководство пользователя

Страница: 15 / 46

AT-GAIN-120 15
PWR
VOL LEVEL
AUDIO AMPLIFIER
FW SIGNAL ANALOG IN
NET AUDIO DEVICE ID
GAIN
TM
LAN
RESET RESET
LINE OUT
CLASS 2 WIRING CLASS 2 WIRING
TRIGGER MODE
MODEL:
dB
-22
-2
-4
-20
-19
-14
-9
-22
-2
-4
-20
-19
-14
-9
dB
ANALOG IN
L
4 / 8 Ω OUT 70V / 100V OUT
AT-GAIN-120
PWR: 100-120VAC 60Hz 120W
220-240VAC 50Hz 120W
L R L R
IP
4Ω
8Ω 100V
70V
R
INPUT GAIN
L R
IP Configuration
The AT-GAIN-120 is shipped with DHCP enabled. Once connected to a network, the DHCP server (if available), will
automatically assign an IP address to the unit. Execute the arp -a command at the Windows command line or use an
IP scanner to locate the AT-GAIN-120 on the network.
If the AT-GAIN-120 is unable to detect a DHCP server, within 15 seconds, then the unit will be assigned the following
IP configuration:
• IP address 192.168.1.254
• Subnet mask 255.255.0.0
• Gateway 192.168.1.1
If a static IP address is desired, the unit can be switched to static IP mode. Use one of the following procedures to
switch between DHCP and static IP mode. 192.168.1.254 is the default static IP address.
Using the Rear Panel
1. Make sure the AT-GAIN-120 is powered.
2. Press and hold the IP RESET button for approximately 10 seconds.
3. Release the IP RESET button once the PWR LED indicator on the front panel begins to flash. The number of
flashes will indicate the currently selected IP mode.
IP RESET button
POWER LED flashes Description
Two Static IP mode
Four DHCP mode
4. Once the unit has changed IP modes, the unit will shut down. To restart the unit, disconnect then reconnect the
power cable.
5. The unit is now set to the new IP mode and ready for use.
Basic Operation