REV. 01 2012
23 / 30
x
With the shims and the supplied anchor bolts in place, tighten by securing the nut to the base.
7.9 ADJUSTMENT OF LIMIT SWITCHES (ref. fig. 16)
Only skilled personnel must be allowed to carry out this operation.
An improper adjustment of limit switches could cause damages to the lift,
objects and people.
Limit switches must be adjusted during the installation of the lift
This lift is equipped with 2 proximity switches for the top position and the safety height position.
Both are to be mounted on the P2 base and can be activated by the slider when it passes by.
If limit switches were not functioning properly, it’s possible to adjust them in the following way:
7.9.1 ADJUSTMENT OF TOP LIMIT SWITCH (fig.16-1)
x
Place the lift at a height of
6 feet;
x
Loosen the nuts (3) of the limit switch and adjust it at the desired height;
x
Tighten the nuts after adjustment.
7.9.2 ADJUSTMENT OF SAFETY HEIGHT LIMIT SWITCH (fig.16-1)
x
Place the lift at a height of
1 foot;
x
Loosen the nuts (3) of the limit switch and adjust it at the desired height;
x
Tighten the nuts after adjustment.
After adjustment of the switches, make sure to fix the switch protection (fig.16-
4) on the base. Failure to do so can damage the switches.
Figure 16 – LIMIT SWITCHES
7.10 LOADLESS
CHECK
Carry out two or three complete cycles of lowering and lifting and check:
x
proper oil level in the tank
x
no leakage and blow-by in hydraulic line
x
cylinders for proper operation
1
2
4
3
Содержание SLP-7K
Страница 10: ...REV 01 2012 11 30 Figure 2 LAYOUT ...
