Loeki and Bello User Guide
4. Operation
No part of this User Guide may be reproduced, stored in a retrieval system, or published, in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of Atlas Revalidatie Techniek BV.
© 2008 Atlas Revalidatie Techniek B.V.
10
4.1.4
Adjusting the angle of the footrest (Bello only)
•
The clamps for adjusting the angle of the footrest are located on both sides of the footrest (see
illustration 6).
•
Loosen the clamps on both sides and adjust the bars to which the footrest is attached to the
desired position. After this, retighten the clamps securely. Make sure that the bars on the left
and the right are at the same angle. Verify that the bars have been securely tightened.
•
If necessary, the angle of the footrests can also be adjusted. This provides the possibility of
setting the ankle and knee angles in an optimal position. Particularly children with poor truncal
balance benefit from this option.
4.1.5
Adjusting the angle of the armrests (Bello only)
•
The clamps for adjusting the angle of the armrests are
located in the middle below the armrests (see illustration 7).
•
Hold on to the armrest with one hand and loosen the clamp
with the other hand. Set the armrest to the desired position
and retighten the clamp securely. Adjust the other armrest so
that it is in the same position. Verify that the armrests have
been securely tightened. Ensure that the tray table is properly
secured and therefore cannot shift while the angle is
adjusted.
•
When necessary, the possibility of adjusting the angle of the
armrests further increases the child’s potential seating
comfort. When the seat is tilted, the armrests (possibly
together with the tray table) can be placed in a horizontal
position again.
4.1.6
The height of the head support
•
The clamp for adjusting the height of the head support is
located at the back of the head support (see illustration 8).
•
Hold on to the head support with one hand and loosen the
clamp for adjusting the height of the head support with the
other hand. Position the head support at the desired height
and retighten the clamp securely. Push up on the head
support to verify that it is properly secured. If the height of the
head support is adjusted this way, it is important to make sure
that the angle of the head support is also adjusted properly.
•
The head support must be able to provide support when the
head is positioned straight above the trunk.
Illustration 6:
Adjusting the angle of the footrest.
Illustration 7:
Adjusting the angle of the armrests
(Bello only).
Illustration 8:
Adjusting the angle of the head
support.
