Atlas 4143400-MT, Руководство по эксплуатации

Страница: 36 / 48

36 PennEngineering • www.pemnet.com
Instruction Manual - RIV938
GENERAL WARNINGS
The operator must read carefully the information given in the present manual, especially with regard to the safety
precautions listed in this chapter. The operator must also observe the warnings listed below:
• The tool shall be used exclusively by trained personnel.
• The tool and the work area shall be kept clean and tidy.
• The tool shall be rested upright on the rubber base on a flat surface to prevent it from falling.
• The tool shall only be used in normal operating conditions.
• The user shall wear suitable clothing taking care to avoid entanglement of loose parts, ties, long hair, cleaning
rags etc. in the tool itself.
• When using the tool, the operator and others nearby should wear safety glasses to protect against fastener
ejection. We also recommend wearing gloves when using the tool.
• The user shall use the accessories supplied when servicing and/or adjusting the tool.
• The plates applied on the tool by Rivit S.r.l. shall not be removed or altered.
• Unauthorized personnel shall not be allowed to touch the tool.
• Make sure that the air supply hoses are correctly sized.
• Do not drag the tool holding it by the hose when it is connected to the power supply. Keep the hose away from
sources of heat and from sharp objects.
• Remember to remove service or adjustment keys after having making a repair and/or adjustment.
• Before disconnecting the compressed air hose from the tool, ensure it is not pressurized.
• Disconnect the air supply before cleaning or making tool repairs.
• Air supply must be disconnected before making tool repairs and cleaning.
• When filling with oil, only use fluids with the characteristics indicated herein.
• If you should accidentally spill oil on your skin, rinse and wash thoroughly with soap and water.
• Where possible, you are recommended to use a safety balance to support the tool.
• Pay attention to possible risk of whiplash with the air supply hoses.
• Do not operate the tool when it is directed towards anyone.
INTENDED USE
The tool is designed exclusively to be used with female threaded type inserts with thread sizes #4-40 to 3/8” / M3 to
M10 and male threaded type studs #8-32 to 5/16” / M4 to M8.
UNINTENDED USE
The tool shall not be used:
• In explosive or aggressive atmosphere or when there is an excessive amount of dust or oil in the air.
• In atmosphere subject to the risk of fire.
• When it is exposed to weather conditions.
RESIDUE RISK
During the normal working cycle and when servicing the tool, the operators are exposed to some residue risks
which, due to the nature of the operations to be carried out, cannot be totally eliminated.
It is therefore absolutely crucial not to exceed the maximum pressure indicated in the technical data section on
page 6.