Installation
25
PVL14OF-EXT
7.7
Attaching Rear Columns To Rear Beam
• Position a rear columns to the rear corner of the lift.
• Place the latch rack into the back of the
column as shown in fi g.17. Pay attention
that the latch rack is offset from the center
line of the thread stud. It should be oriented
toward the back of the column from the
center line of the thread stud.
• Insert the thread stud of the latch rack
through the hole of the top plate and fi t two
M20 nuts into the thread stud of the latch
rack. Adjust the nuts down the thread stud
until the nut and the top plate are fl ush.
• Install the pulley and the nylon spacers on
the rear beam as shown in fi g.18.
• Raise the latch rack above the sliders as
shown in fi g.19 and move the column toward
the rear beam until the sliders contact the back of the column.
• Lower the latch rack into the sliders as shown in fi g.19.
• Adjust the nuts on the thread stud of the latch rack against the column top
plate so that the latch rack should engage the sliders for at least 25mm
when the lift is lowered completely.
• Repeat the above procedures to attach another rear column to the rear
beam.
