9
11. OPERATING THE
REMOTE CONTROL
LEARN MODE PROCESS
1.
Control and receiver have been factory
programmed. If replacing the transmitter or
receiver, the learn mode process will need to be
used. (Fig. 16)
2.
After installing the unit and restoring power
to
your fan, open the battery cover (with
battery,
DC12V/A23 1pc, installed) and press and
hold the
”LEARNING BUTTON” 3~5seconds
with a
ball-point pen or similar object. Light
will flash
twice and turn off, which indicates that
the learning
process has completed.
IMPORTANT:
You must press the “LEARNING
BUTTON” within 30 seconds of restoring power to
the fan. Remote does not need to be re-learned
when replacing the battery.
3.
Please note, the remote can learn multiple
receivers. Please make sure not to learn with
other receiver during the learning process.
OPERATING YOUR REMOTE CONTROL
To prevent damage to transmitter, remove the
battery if not used for long periods.
A. H, M, L Buttons:
These buttons are used to set the fan speeds as
follows: (Fig. 17)
L: Low Speed
M: Medium Speed
H: High Speed
B.
OFF Button:
This button turns the fan off. When fan is turned
off, a momentary increase in speed can occur
before the fan slows and then finally stops.
D. Button:
This button is used to turn the light kit
on/
off.
Figure 16
Figure 17
Learning
button
DIMMER
ON/OFF
Light dimmer function
select switch
