42
5.
Test with load
After finishing the above adjustments, test run the lift with a load. Run the lift in low
position for several times first, raising and lowering, make sure the lift can raise and
lower synchronously and the safety device can lock and release synchronously.
Then test run the lift to full rise. If there is anything improper, repeat the above
adjustment and re-test operation.
NOTE: Lift may vibrate when first used, after lifting it with a load several times
the air will bleed and the vibration should disappear automatically.
Hydraulic Schematic Diagram
Fig. 53
Содержание Atlas PV-10HPX
