Atlas Copco SF 1, Инструкция

Страница: 30 / 54

Period
(note 1) Running
hours
(note 1) Operation
Every 6
months
(note 2) -- Compressors with integrated dryer:
• If dirty, brush or blow off the finned surface of the dryer's condenser.
• Inspect and clean the electronic drain:
• Functioning of the drain can be checked by pushing the TEST
button of the drain.
• Cleaning of the drain filter can be done by opening the manual
drain valve during a few seconds.
Yearly 2500 • Replace the air inlet filter(s) (AF) and the prefilter mats on the cooling air
intake openings (if fitted) (note 2).
• Test the safety valve.
• Have temperature protection and motor overload tested.
• Check tension and condition of the V-belt(s).
Every 2
years 5000 • Replace the V-belt(s).
• Replace check valve.
Every 2
years 5000 8 bar and 116 psi compressors:
Have the orbiting scroll bearing greased (see note 3).
Every 2
years 5000 10 bar and 145 psi compressors:
• Replace the element outlet pipe and the plastic insert. See section Outlet
pipe replacement .
(Only on SF 1, SF 2 and SF 4)
• Clean fan (FN1 - see Flow diagram ), fan duct and element cooling fins
(see note 2).
• Have orbiting scroll bearing and pin crank bearings greased (see note 3).
• Replace tip seals and dust seal (see also note 4).
Every 4
years 10000 8 bar and 116 psi compressors:
• Replace the element outlet pipe and the plastic insert. See section Outlet
pipe replacement .
(Only on SF 1, SF 2 and SF 4)
• Clean fan (FN1 - see Flow diagram ), fan duct and element cooling fins
(see note 2).
• Have orbiting scroll bearing and pin crank bearings greased (see note 3).
• Replace tip seals and dust seal (see also note 4).
Notes:
1. Maintenance must be done according the number of running hours or according the running period,
whichever comes first.
2. More frequently in a dusty environment.
3.
Important note: Greasing of the bearings of the compressor element must be done with special
grease , a special grease gun and according a specific procedure .
In high ambient conditions, the bearings must be greased more frequently: for every 5 °C (9 °F)
increase above 30 °C (86 °F), the maintenance interval should be reduced with 30 %.
Contact your supplier for details.
4. In extremely dry conditions (relative humidity below 15 %), the tip seals and dust seals need to be
replaced more frequently.
Instruction book
28 2920 7110 11