7
PAGE
Repair Instructions No.163.01/96
PHE 20 / PHE 26 / PHE 200
Mounting the
wheel shaft
1
Completely assemble the wheel shaft (6)
and press the reduction gear flush onto
the wheel shaft.
☞
Use a new bearing cover (7).
2
Insert the complete wheel shaft into the
motor housing (8) and fasten it with
screws. Additionally secure the screws
with screw locking device.
3
Insert the percussion body (4) and the pis-
ton con-rod (5) together with the four-lip-
seal-ring into the cylinder (3).
4
Insert the cylinder (3) into the motor hous-
ing (8) and insert the con-rod into the
wheel shaft tappet.
5
Insert the field and the air deflector
plate (9) into the motor housing (8).
6
Fasten the pre-assembled bearing end
plate with screws to the gear box. Addi-
tionally secure the screws with Omnifit.
7
Fasten the completed gear box to the mo-
tor housing (8) with screws. Additionally
secure the screws with Omnifit.
8
Fit the housing cover (1) together with the
gasket and fasten it with screws.
Mounting the
carbon brushes
1
Insert the carbon brushes (9) into the
brush holders (8) and mount the plug con-
tacts.
2
Insert the brush holders (8) with the car-
bon brushes (9) above the armature col-
lector into the reliefs of the lower handle
shell (1). Take care that the strands of the
armature collector keep free.
3
Install the switch (2) and the capacitor (7) to-
gether with all the strands into the provided
reliefs of the handle shell (1) and connect
them according to the wiring diagram.
4
Mount the power supply lead and the ca-
ble entry sleeve (6) with the cable clip (3).
Connect the power supply lead according
to the wiring diagram.
5
Fasten the upper handle shell (4) with the
five screws (5).
Test Run
Electrical Test
Check the direction of rotation!
Let the machine run-in.
Perform an electrical test on the machine (see chapter Electrical and Mechanical Test Instructions).
8
7
6
5
4
1
9
2
3
4
2
3
4
5
6
7
8
9
1
5
Содержание PHE 20
Страница 1: ......
