Atlas Copco HiLight H4 Kd ESF, Инструкция по эксплуатации

Страница: 33 / 94

- 33 -
4.3 Connecting appliances
1. Start the engine. See section 4.2.2.
2. Wait 3 or 4 minutes before connecting the
appliances to allow the engine to warm up
enough. Then plug in the socket (X1) (1).
3. Make sure that a correct voltage is displayed.
4. Switch on circuit breaker Q6.
5. Switch on your appliance.
6. If the breaker Q6 (2) trips (10 A), adjust the load
until it falls within the maximum power limit
allowed.
7. Make sure that the load does not exceed the
nominal power of the generating set as indicated
in the technical data sheet and guaranteed with a
tolerance of ± 5% when the engine has run in.
For derating values, check the derating table on
page 74.
8. Make sure the load does not exceed the nominal
current capacity of the socket or the cable
connected to it.
9. Only connect the light tower directly to the mains,
if the optional External power input (230 VAC) is
installed. In this case use the X2 socket (3). See
also “External power input (230 VAC), with
battery charger” on page 66.
10. Stop the engine. See section 4.2.8.
Keep in mind that this machine is a
light tower, not a generator set!
Power is limited to 10 Amps!
Q2 Q3 Q4 Q5 Q1
40A/30mA
Q6
X1
X2
0
1
P8
GE
ON
Q1 Q2 Q3 Q4 Q5 Q6
1
2
If the 4 lamps are switched ON and
the load of the socket is exceeded, an
Under voltage alarm will be
triggered and the engine will
shutdown.
Avoid long low-load periods
(< 30%). In this case, an output
drop and higher oil consumption of
the engine could occur. Refer to
‘Preventing low loads’.
To correctly disconnect the
appliances from the light tower
generator, first position the switch to
OFF to isolate the electric load and
only then remove the plug.
Q2 Q3 Q4 Q5 Q1
40A/30mA
Q6
X1
X2
0
1
P8
GE
ON
Q1 Q2 Q3 Q4 Q5 Q6
3
00_00_HiLight H4_EN.book Page 33 Monday, April 18, 2016 2:10 PM