Atlas Copco HiLight H4 Kd ESF, Инструкция по эксплуатации

Страница: 24 / 94

- 24 -
3. Adjust the height of the support leg/jockey wheel
using the handle (2) on top. The support leg/
jockey wheel (3) should never touch the ground
once the light tower is coupled to the hook of the
towing vehicle.
4. Use the handle at the top of each foot to retract the
4 feet and retract the front stabilizers and ensure
their locking pins following the reverse order of
the procedure described in “Positioning the light
tower” on page 22.
Once all the above operations are complete, you will
have returned the light tower to the same state as it
was before the positioning procedure (see figure
above). At this point the light tower is correctly
arranged for transport.
3.2.4 Towing
Before commencing towing, ensure you follow the
procedure below:
1. Check that the coupler (1) of the undercarriage of
the light tower is safely coupled to the towing
hook of the towing vehicle.
2. Connect the cabling plug to the towing vehicle so
that the rear lights of the light tower work
(indicators, lights, brake lights).
3. Check that the pressure and condition of the tires
are suitable for the road and the climatic
conditions.
4. Release the handbrake (2), if provided.
2
3
4
Do not proceed with towing if you
notice any broken or faulty parts.
Drive carefully according to the
road and climatic conditions.
Keep in mind that for the low speed
off-road non-homologated trailer,
the maximum speed is 20 Km/h!
2
1
00_00_HiLight H4_EN.book Page 24 Monday, April 18, 2016 2:10 PM