Installing the rotating
mechanism
Hydraulic compactors HC 350 to HC 1055 can be
fitted with a rotating mechanism. Install the rotating
mechanism in a workshop.
♦
Unpack the rotating mechanism and all parts
enclosed with the delivery.
♦
Remove all the packaging material.
♦
Separate the packaging materials (wood, metal,
plastic, …) and hand them in for recycling.
♦
Check that the delivery is complete.
♦
Check the delivery for visual damage.
♦
If any defects are found, consult the Atlas Copco
Customer Center/dealer in your area.
♦
Remove the hydraulic compactor from the carrier
(see chapter
Removing the hydraulic attachment
from the carrier
).
♦
Remove the outer housing (see the chapter
Replacing worn rubber isolators
).
♦
Deposit the outer housing on level ground.
WARNING Hands and fingers being cut off
or hurt
Bores and surfaces can act like a pair of scissors
and cut off or hurt parts of your body.
►
Never use your fingers to check bores or fitting
surfaces.
♦
Fit a pair of lock washers onto every screw.
P
T
P
T
R
♦
Insert the screws from above through the holes in
the rotating mechanism.
♦
Align the rotating mechanism so that both
connections on the oil distributor transversally
point to the outer housing.
♦
Place the rotating mechanism on the outer
housing, so that the screws slide into the holes in
the outer housing.
♦
Put a pair of lock washers on every screw from
below and screw the nuts onto the screws.
♦
Tighten the nuts with the required tightening
torque.
Tightening
torque
Spanner size
Model
295 Nm
14 / 24 mm
HC 350
295 Nm
14 / 24 mm
HC 450
295 Nm
14 / 24 mm
HC 850
580 Nm
17 / 30 mm
HC 1050
580 Nm
17 / 30 mm
HC 1055
© 2014 Construction Tools EOOD | No. 3390 5121 01 | 2014-11-19
Original instructions
20
HC 150, 350, 450, 850, 1050, 1055
INSTALLATION
