Atlantic SOLIUS, Документация по установке и использованию

Страница: 13 / 40

13
5/
Locking the device onto the hanging frame
Operation
You can run your device in several modes:
•
Comfort mode which enables you to have the right ambient temperature.
• Eco mode which enables you to lower the temperature in your room when you will be away from your home for a
long time
• Programming mode which enables you to programme the Comfort and Eco modes according to how a room
will be occupied
Control box
V1 Heating light indicator
A Mode cursor
B
Temperature adjustment control knob.
Use
Setting the comfort temperature
This is the temperature desired when the room is occupied.
Set cursor
A
to position , the indicator
V1
lights.
Adjust knob
B
to 5. The heating indicator
V1
will illuminate if the tem-
perature is below the desired temperature.
Wait a few hours for the temperature to stabilise.
When you are happy with the setting (
you may wish to use a thermome-
ter to check ), mark the position once and for all. If you are not happy
with the setting, re-adjust it and proceed again.
Setting the Eco temperature
This involves a reduction in degrees compared to the Comfort temperature. We recommend that you use this
mode for periods of absence of more than 2 hours or overnight.
Set switch
A
to . The device is now in Eco mode ( Comfort temperature minus approx. 3°C to 4°C ).
Programming mode
The device is fitted with a thermostat that can be controlled via the control wire. It recognises the following com-
mands:
NB : If no commands are received via the control
wire, the device operates in Comfort mode.The
frost-free and power interruption commands are
prioritised over the Eco and Comfort modes.
When switching from Comfort to Eco mode, the
switchover time is around 12 seconds.
PROG
Ordre Abaissement
ECO -3,5°C
HORS GEL Ambient temperature maintained at around 7°C.
ARRET
Stopping the heating immediately ( used for power
cutoff ).
12
13
11
9
10
6/ Maintenance
To maintain the performance of the device, the upper and lower grills
must be cleaned with a vacuum clener or a brush approximately twice
per year.
Do not use abrasive products.
GB