ATIKA AMF 2300, Оригинальные инструкции, Инструкции по безопасности, Запасные части

Страница: 15 / 166

15

The machine should only be operated in the open. Always
maintain a safe distance (at least 2 m) from walls or other
fixed objects.

Do not operate the machine in bad weather conditions.

Before each use:
−
Check the supply / extension cable for damages (cracks,
cuts or the like) or ageing (brittleness).
Do not use defective supply or extension cables.
−
Check there is no damage at the machine (see safety
instructions).
−
Make sure that the shredder tool is neither worn out nor
damaged and that it is properly secured.
−
Check that all screws, nuts and bolts as well as other
fasteners are securely tightened
−
Check that covers, deflectors and protective shields are
on their correct position and in good working condition.
Mains connection

Compare the voltage given on the machine model plate e.g.
230 V with the mains voltage and connect the machine to the
relevant and properly earthed plug.

Connect the machine via a circuit breaker switch (residual-
current-operated circuit switch) 30 mA.

Always use three-conductor extension cables with connected
earthing conductor and sufficient cross section.

In case of disadvantageous power system conditions short-
term voltage reductions can occur during the starting process
of the device which can influence other devices (e.g. jittering
of a lamp). No failures are expected when the house service
connection has a continuous current-carrying capacity
greater than 100 A per phase.
Mains fuse
Switzerland UK
2300 W 16 A time-lag 10 A time-lag 13 A time-lag
2500 W 16 A time-lag 13 A time-lag
2800 W 16 A time-lag 13 A time-lag
On / Off switch
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired or
replaced immediately by the customer service.
Switch on
Press the green button .
Switch off
Press the red button .
Restart protection in case of power failure
In case of a power failure, the device switches off automatically
(zero-voltage initiator). To restart, press the green button again.
Motor protection
The motor is equipped with a safety switch and switches off
automatically when overloaded. After a cooling-down break
(approx. 5 min), the motor may be restarted. Press the
1. reset button (motor protection)
2. green button to restart.

Use a tamper or hook to remove jammed objects from the
hopper or ejection slot.
Always wait until the shredder has come to a complete
standstill before restarting it.
Retaining basket
The integrated retaining basket is equipped with a locking
lever and a safety cut-out device.

Power off the device before attaching or removing the
re-taining basket.

Retaining basket locked and fixed connected to
the device.

Retaining basket unlocked and disconnected
from the device. The device cannot be powered
up.

When the retaining basket is unlocked while the
device is operating the device is automatically
cut out.
Always wait until the shredder has come to a complete
standstill before restarting it.
Working with the garden shredder

Choose a working position alongside the equipment. Never
stand near the ejection opening.

Provide a safe standing position and keep at any time the
balance. Do not lean forward. When placing material into the
shredder, always stand on the same level as the machine.

Always keep away from the ejection area when starting the
machine.

Longer material that is protruding from the device
could spring back when it is drawn in by the blades!
Observe safety distance!

Use the supplied stuffer to restuff material to be shredded.

Never reach into the filling or ejection opening.

Keep your face and body away from the filling opening.

Never place hands, other parts of the body or clothing into
the filler funnel, ejection channel or in the vicinity of other
moving parts.