16
Check before powering the device up that:
−
no material residues are in the filling hopper,
−
the retaining basket is locked.
Do not tilt or transport the machine (relocation) while the
motor is running.
Make sure that the motor is free from waste material and
other material accumulation to protect it against damage and
to prevent fire.
When filling, be careful that no pieces of metal, stones,
bottles or other objects unintended for processing, enter the
filling hopper.
Power off the device before attaching or removing the re-
taining basket.
Immediately switch off the equipment and allow it to come to
a stop, if foreign objects enter the filling hopper or if the
equipment starts to make unusual noises or vibrates.
Remove the mains plug and carry out the following checks:
−
inspect for damage,
−
replace or repair damaged parts,
−
check the equipment and tighten loose parts.
You must not repair the equipment yourself if you are
unauthorized to do so.
What can I shred?
Yes:
•
Garden waste
e. g. hedge and tree cuttings, dead flowers
No:
•
glass, metal, plastic, plastic bags, stones, cloth, roots with
soil, food left-overs, fish or meat.
Special tips on shredding:
Branches, twigs and wood should be broken down
immediately after they have been cut.
−
Material of this kind gets very hard when it is dry, and the
maximum allowed branch diameter to be processed has
to be reduced.
Remove any side shoots from branches with a large number
of twigs.
Processing of garden waste that contains much water and is
prone to agglutinating
−
to prevent the machine from clogging, alternate such
waste with wood containing material.
Do not allow the shredded material to pile up too high in the
area of the ejection opening. This can lead to shredded
material blocking the ejection channel, and backing up to the
filler opening.
Clean out the filler opening and ejection channel thoroughly if
the machine becomes blocked. Before doing this, switch the
motor off and disconnect the machine from the mains power
supply.
Please do not exceed the maximum branch diameter
specified (cutting fresh wood) for your appliance (
∅
see
“
Technical data
”
). Depending on the wood
’
s nature and
freshness the maximum branch diameter the machine can
process may be smaller.
The blades largely pull the material into the machine by
themselves.
Strong branches may cause overloading. This can be
avoided by pulling them back from time to time.
If the machine is overloaded, a protective motor switch
ensures that the machine turns itself off automatically.
−
Turn the shredder on again after about 5 minutes.
−
If you cannot turn on the machine after this waiting time
refer to „Operational faults
“
.
Changing the blades
Remove the mains plug before changing the
blades.
Risk of injury to the fingers and hands when carrying
out work on the blade unit. Wear protective gloves.
Reduced output
One edge of the knife has become blunt:
Turn knife so that you can use the other edge.
All knive edges have become blunt:
Replace with new set of knives (order-no. 382425).
Always replace worn and damaged blades as a whole set
to prevent any unbalance.
Open the machine.
1. Open the machine by removing the
locking screw.
2. Fold down
the housing cover.
Turning or replacing the knives
1. The slot in the knife plate (18) must be aligned with the slot in
the counter knife (15). Insert a screwdriver through the slots
to fix the knife plate.
2. Remove the screws. Turn the knife or replace it.
3. To turn or replace the second knife remove the screwdriver
and turn the knife plate. Repeat then the steps 1 and 2.
