16
A
A
d
d
j
j
u
u
s
s
t
t
i
i
n
n
g
g
t
t
h
h
e
e
f
f
i
i
x
x
e
e
d
d
c
c
o
o
u
u
n
n
t
t
e
e
r
r
b
b
l
l
a
a
d
d
e
e
The cutting unit has been adjusted at
the factory and need not be adjusted
prior to being put into operation for the
first time.
It is possible to adjust the counter blade
B at the cutting roller A free of
clearance. For an effective operation, an
as small as possible clearance should
be maintained.
Soft material or wet branches may tear
instead of being cut. A counter blade
that is worn after repeated use may also
lead to this problem.
Setting the clearance.
Switch on the device.
There is an adjustment device on the
right hand side of the plastic housing. To
adjust the clearance, insert the supplied socket wrench D and turn it to the right so that the screw C moves towards the cutting
roller. Turn until fine aluminium chips are falling from the ejection slot.
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
a
a
l
l
f
f
a
a
u
u
l
l
t
t
s
s
Fault Possible
cause Remedy
Motor does not start
−
No power supply
−
Mains cable defective
−
Machine overloaded
−
Check fuses
−
have these checked (electrician)
−
Overload protection triggered
Turn On-Off switch to "0" and let machine cool down
Motor hums but does not
start
−
Cutting roller blocked
−
Capacitor faulty
−
Turn On-Off switch to left, then switch machine off and
remove shredding material. If the blockage cannot be
removed immediately switch the On-Off switch between
cutting and reverse a number of times until the cutting
roller runs free.
−
Bring machine to manufacturer or authorised workshop
for repair
Shredding material is not
drawn into the shredder
−
Incorrect switch position
−
Shredding material caught in funnel
−
Machine clogs
switch-over in the direction of rotation
−
Shredding material too soft or wet
−
Cutting roller worn
−
Turn On-Of switch to correct position
−
Turn On-Off switch to left to release shredding material,
remove any dirt
−
Switch off unit. Wait until the blades come to a
standstill. Switch unit back on and use material which is
easier to process.
−
Push down with a branch and shred
−
Adjust shaving plate as described in "Adjusting the
fixed counter plate, replace cutting roller if heavily worn
Shredding material not cut
cleanly
Incorrect setting of counter blade
Adjust counter blade, if this cannot be adjusted it has to
be replaced by the customer service department.
Device starts but blocks
under as slight load and
switches off via protective
motor switch.
Extension cable too long or cross-
section to small.
Socket too far from mains supply and
cross-section of mains cable too small
Extension cable at least 1.5 mm², maximum 25 m long. If
a longer cable is used, minimum cross-section 2.5 mm².
