IDA8 Installation Guide
2
© 2021, ATEÏS, member of PAX ProAV Group
Hardware installation & connection
Rack mounting
Mount the IDA8C/IDA8C-SW/IDA8SAB/IDA8SL
unit in any standard 19-inch 2U audio equipment
rack using the supplied mounting brackets and
screws. Installing a IDA8S unit is similar to
installing a IDA8C, except the IDA8S unit is
installed in 19-inch 1U rack-mounting.
Consider leaving enough ventilation space above
and below the unit. Do not mount the controller
directly above the heat generating devices like
power supplies or power amplifiers.
Power supply
Use the supplied AC power cable to connect the
IDA8C/IDA8C-SW/IDA8SAB/IDA8SL unit to he
power outlet, and IDA8S unit by 24VDC. The
Power LED on the front panel will glow green
when power is applied.
If 24VDC power and AC mains power are
connected at the same time, IDA8C/IDA8C-SW/
IDA8SAB/IDA8SL will use AC power first, and
switch to DC power if there AC mains is not
present.
Ethernet (RJ45)
Use the supplied Ethernet cable (CAT5/6) to
connect the IDA8C processor to a computer.
The PC-based Ateis Studio software shall provide
all the necessary tools to setup, configure,
control and monitor the entire system.
ATEIS network
Local-net
Connect 1 IDA8C with another IDA8SAB unit
via Ateis local-net.
